Ask the dedicated volunteers of the development task groups what the documents address in the work of electronics assembly, and they will quickly tell you J-STD-001 is for the soldering process and IPC-A-610 is for inspection. J-STD-001 and IPC-A-610 have been around for decades. Within the assembly standards, we see J-STD-001 first, followed by IPC-A-610, and this is where the story of using the two documents together starts. The standards in the trunk tell a story from data transfer and design, to materials and printed board fabrication, and then to printed board assembly. When we look at IPC’s Simplified Standards Tree (FIGURE 1), we see IPC’s most widely used standards in the trunk of the tree and the supporting standards in the branches on either side of the trunk. To understand how to implement J-STD-001, Requirements for Soldered Electrical and Electronic Assemblies and IPC-A-610, Acceptability of Electronic Assemblies, we must first understand each individual standard. But those planning to use both must identify who is responsible for key requirements.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |